NAVIGATION SYSTEM > Stereo Component Amplifier Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (STEREO COMPONENT AMPLIFIER ASSEMBLY - BATTERY AND BODY GROUND) |
![]() |
Disconnect the N11 and N14 stereo component amplifier assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N14-2 (GND) - Body ground | Always | Below 1 Ω |
| N14-6 (GND2) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N14-1 (+B) - N14-2 (GND) | Always | 11 to 14 V |
| N14-3 (+B2) - N14-2 (GND) | Always | 11 to 14 V |
| N11-12 (ACC) - N14-2 (GND) | Ignition switch ACC | 11 to 14 V |
| *a | Front view of wire harness connector (to Stereo Component Amplifier Assembly) |
|
| ||||
| OK | ||
| ||