Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Data Signal Circuit between Navigation Receiver Assembly and Extension Module

for Preparation Click here


DESCRIPTION

The stereo component tuner assembly sends the sound data signal or image data signal from a device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM


E282848E03


INSPECTION PROCEDURE

NOTICE:
After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, registration of the XM radio ID is necessary.

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT TUNER ASSEMBLY)
  1. Disconnect the s1 and t1 navigation receiver assembly connectors.

  1. Disconnect the s2 and t2 stereo component tuner assembly connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    s1-1 (USV4) - s2-1 (USV4)
    Always
    Below 1 Ω
    s1-2 (US4-) - s2-2 (US4-)
    Always
    Below 1 Ω
    s1-3 (US4+) - s2-3 (US4+)
    Always
    Below 1 Ω
    s1-4 (UGD4) - s2-4 (UGD4)
    Always
    Below 1 Ω
    s1-5 (USG4) - s2-5 (USG4)
    Always
    Below 1 Ω
    t1-4 (+B2) - t2-4 (+B2)
    Always
    Below 1 Ω
    t1-3 (ACC2) - t2-3 (ACC2)
    Always
    Below 1 Ω
    t1-8 (GND2) - t2-8 (GND2)
    Always
    Below 1 Ω
    s1-1 (USV4) - Body ground
    Always
    10 kΩ or higher
    s1-2 (US4-) - Body ground
    Always
    10 kΩ or higher
    s1-3 (US4+) - Body ground
    Always
    10 kΩ or higher
    s1-4 (UGD4) - Body ground
    Always
    10 kΩ or higher
    s1-5 (USG4) - Body ground
    Always
    10 kΩ or higher
    t1-4 (+B2) - Body ground
    Always
    10 kΩ or higher
    t1-3 (ACC2) - Body ground
    Always
    10 kΩ or higher
    t1-8 (GND2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.REPLACE NO. 1 NAVIGATION WIRE
  1. Replace the No. 1 navigation wire (Click here).

  1. Check that the malfunction disappears.

    OK:
    Malfunction disappears.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (NO. 1 NAVIGATION WIRE IS DEFECTIVE)