WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS > PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Each inspection procedure refers to the TOYOTA Repair Manual.

PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

Replacement Part
Necessary Procedure
Effect/Inoperative Function when Necessary Procedures are not Performed
ECM
Vehicle Identification Number (VIN) registration
MIL comes on
ECU communication ID registration (Engine immobiliser system)
Engine start
  1. TCM
  2. Automatic transmission assembly
  3. Valve body assembly
  4. Transmission wire
  5. Shift solenoid valve S1, S2, S3, S4, SL1, SL2, SLT, SLU, and/or SR
  6. Engine assembly
Reset memory
  1. Large shift shock
  2. The deterioration of fuel efficiency
  1. Brake actuator assembly (Skid control ECU)
  2. Steering sensor
  3. Steering column assembly
  4. Rack and pinion power steering gear assembly
  5. Adjust front wheel alignment
VSC sensor neutral memorization
VSC system does not operate normally (warning indicator light comes on).
Power steering ECU assembly
Rotation angle sensor initialization and torque sensor zero point calibration
  1. P/S warning light comes on
  2. EPS control
Steering column assembly
Rotation angle sensor initialization and torque sensor zero point calibration
Steering effort is different between turning steering wheel to left and right
w/ Entry and Start System
  1. Electrical key transmitter sub-assembly
  2. ID code box (immobiliser code ECU)*1
  3. Certification ECU (smart key ECU assembly)
Registration
  1. Wireless door lock/unlock operation
  2. Entry operation
  3. Engine starting
  4. Steering lock/unlock
w/ Entry and Start System
  1. Steering lock ECU (steering lock actuator assembly)
Registration
Engine start
w/o Entry and Start System
  1. Key
  2. Main body ECU (network gateway ECU)
  3. Combination meter assembly*2
  4. Transponder key ECU assembly*3
Code registration (Engine immobiliser system)
Engine start
w/o Entry and Start System
  1. Door control transmitter module set sub-assembly
  2. Door control receiver
Code registration (Wireless door lock system)
Wireless door lock/unlock operation
  1. Height control sensor subassembly RR
  2. Headlight leveling ECU assembly
Perform headlight leveling ECU assembly initialization
Headlight leveling function
  1. Power window regulator motor assembly
  2. Door window regulator sub-assembly
  3. Door glass
  4. Front door frame sub-assembly rear lower
  5. Front door sush
  6. Front door opening trim weatherstrip
Initialize power window control system
  1. Auto up/down function
  2. Jam protection function
  3. Operation function after ignition switch is turned off
  1. *1: w/ ID Code Box
  2. *2: w/o Transponder Key ECU Assembly
  3. *3: w/ Transponder Key ECU Assembly