ENGINE COMPARTMENT REFERENCE VALUES > THREE-DIMENSIONAL DISTANCE


HINT:
  1. Measure points with the engine cover removed.
  2. In cases in which only one dimension is given, left and right are symmetrical.
  1. For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).


Measuring Point Name 
Symbol
Name
Hole Diameter
mm (in.)
A, a
Front Bumper Side Support Installation Bolt
M6 (0.24)
B, b
Headlight Installation Bolt
M6 (0.24)
C, c
Front Fender Installation Bolt
M6 (0.24)
D, d
Front Fender Installation Bolt
M6 (0.24)
E, e
Front Fender Apron Patch Installation Bolt
M6 (0.24)

K135356E01