UNDER BODY REFERENCE VALUES > THREE-DIMENSIONAL DISTANCE


HINT:
  1. Measure points with the engine under cover removed.
  2. In cases in which only one dimension is given, left and right are symmetrical.
  1. For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).


Measuring Point Name 
Symbol
Name
Hole Diameter
mm (in.)
A, a
Front Arm Plate Installation Bolt
M14 (0.55)
B, b
Sub Frame Installation Bolt
M10 (0.39)
C, c
Sub Frame Installation Bolt
M10 (0.39)
D, d
Front Side Member Standard Hole
φ18 (0.71)

K104860E01