QUARTER PANEL END HOUSING > ASSEMBLY REPLACEMENT


K105090

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100016
Remove Weld Points
K100023
Cut with Disc Sander etc.
REMOVAL POINT
  1. Cut the quarter panel and fold it upward as shown in *1. Then cut through the welded area of the quarter panel inner rear and quarter inner panel rear, and remove the quarter panel extension rear lower.

K105091E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100021
Plug Weld
K100027
Butt Weld
INSTALLATION POINT
  1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
  2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
  3. After welding, apply body sealer to the corresponding parts. (See the painting / coating)
  4. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K105092E01