REAR FLOOR PAN > CUT AND JOIN REPLACEMENT SECTIONS



  1. K105096
    With the body lower back panel removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100015
Remove Weld Points
K100016
Remove Weld Points
K100022
Cut with Disc Sander etc.
K100025
Cut Location
REMOVAL POINT
  1. After removing the rear floor side panel and rear bumper bracket, remove the rear floor pan.

K105097E01


K105098E01


K105099E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100020
Plug Weld
K100021
Plug Weld
K100025
Cut Location
K100026
Fillet Weld
K100030
Body Sealer
INSTALLATION POINT
  1. Cut the new part so that it overlaps the previous cut location.
  2. When welding *2, make a hole on a new part for plug welding and weld the panel with the panel behind completely.
  3. *1: Perform plug-welding in the area where the panel are overlapped. Apply body sealer to both sides of each panel.

    HINT:
    1. Confirm that the panels are securely welded together.
    2. Apply body sealer in an even, continuous bead.

  4. After welding the rear floor pan to the vehicle side, install the rear floor side panel and rear bumper bracket.
  5. After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
  6. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K105100E01


K105101E01


K105102E01