REAR FLOOR SIDE PANEL > ASSEMBLY REPLACEMENT



  1. K105103
    With the body lower back panel removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100015
Remove Weld Points
K100016
Remove Weld Points
K100022
Cut with Disc Sander etc.
REMOVAL POINT
  1. After removing the rear floor side panel and rear bumper bracket, remove the rear floor pan to quarter panel extension.

K105097E01


K105106E01


K105098E01


K105107E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100020
Plug Weld
K100021
Plug Weld
INSTALLATION POINT
  1. When welding *1, make a hole on a new part for plug welding and weld the panel with the panel behind completely.
  2. After welding the rear floor pan to quarter panel extension to the vehicle side, install the rear floor side panel and rear bumper bracket.
  3. After welding, apply body sealer to the corresponding parts. (See the painting / coating)
  4. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K105108E01


K105101E02


K105109E01


K105102E02