With the front fender mounting bracket and front body pillar lower gusset removed.
REMOVAL
Symbol meaning
Remove Weld Points
Remove Weld Points
Cut with Disk Sander etc.
INSTALLATION
Symbol meaning
Plug Weld
Plug Weld
Fillet Weld
INSTALLATION POINT
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram)
Make sure to attach correctly in accordance with the body dimension diagram as this part affects the front wheel alignment.
After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.