FRONT SIDE MEMBER > ASSEMBLY REPLACEMENT (PATTERN 1)



  1. K105346
    With the radiator support and front fender mounting bracket removed.

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100016
Remove Weld Points
K100022
Cut with Disk Sander etc.
REMOVAL POINT
  1. After removing the front side member reinforcement No.1, remove the front side member sub-assembly.

K105061E01


K105062E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100021
Plug Weld
K100026
Fillet Weld
INSTALLATION POINT
  1. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
  2. After welding the front side member sub-assembly to the vehicle side, install the front side member reinforcement No.1.
  3. Make sure to attach correctly in accordance with the body dimension diagram as this part affects the front wheel alignment.
  4. After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
  5. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K105063E01


K105064E01