FRONT SIDE MEMBER > ASSEMBLY REPLACEMENT (PATTERN 2)
With the radiator support and front fender apron removed.
REMOVAL
Symbol meaning
Remove Weld Points
REMOVAL POINT
After removing the front side member reinforcement No.1, remove the front side member sub-assembly.
INSTALLATION
Symbol meaning
Plug Weld
INSTALLATION POINT
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
After welding the front side member sub-assembly to the vehicle side, install the front side member reinforcement No.1.
Make sure to attach correctly in accordance with the body dimension diagram as this part affects the front wheel alignment.
After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.