CENTER BODY PILLAR > CUT AND JOIN REPLACEMENT SECTIONS



  1. K105350
    With the quarter panel removed.
  1. Weld work for 980 MPa ultra high strength steel
Follow the welding conditions below when welding ultra high strength steel to assure sufficient weld strength. (When repairing this model)
  1. *1: When welding 2 panels together including 980 MPa ultra high strength steel.

    Plug weld
    Plug diameter
    10 mm (0.39 in.)
    Wire type
    AWS A5.18 ER70S-3
    Shield gas
    Metal active gas
  1. *2: When welding more than 3 panels together including 980 MPa ultra high strength steel. (When plug welding a third panel to 2 panels which are welded under the conditions described above.)

    Plug weld
    Plug diameter
    Same as the standard method (See the introduction)
    Wire type
    AWS A5.18 ER70S-3
    Shield gas
    Metal active gas

REMOVAL

Symbol meaning
K100014
Remove Weld Points
K100016
Remove Weld Points
K100022
Cut with Disc Sander etc.
K100023
Cut and Join Location
REMOVAL POINT
  1. Do not butt weld or heat repair because the heat decreases the strength of areas where ultra high strength steel is used. (See the introduction)
  2. *3 is reused.

K137313E01


K105139E01


INSTALLATION

Symbol meaning
K100019
Plug Weld
K100021
Plug Weld
K100023
Cut and Join Location
K100026
Fillet Weld
K100027
Butt Weld
INSTALLATION POINT
  1. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
  2. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
  3. If the entire supply part is not needed, remove the part of the supply part that is needed.
  4. Follow the welding conditions when welding *1 and *2 to assure sufficient weld strength. (See the introduction)
  5. Before temporarily installing the new parts, weld the center body pillar reinforcement sub-assembly and rocker reinforce sub-assembly outer with the standard number of welding points.
  6. After welding the No.1 inner pillar sub-assembly the vehicle side, install the center body pillar reinforcement sub-assembly and rocker reinforce sub-assembly outer.
  7. After welding the No.1 inner pillar sub-assembly, center body pillar reinforcement sub-assembly and rocker reinforce sub-assembly outer the vehicle side, install the *3.
  8. After welding, apply body sealer to the corresponding parts. (See the painting / coating)
  9. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

K105140E01


K137314E01


K137315E01