Function
| Outline
|
Start Function
| The start function is operated by simply pressing the push start switch while carrying the key. When the push start switch is pressed, the smart key ECU assembly turns on/off the ACC relay, IG1 relay, and IG2 relay to switch the power source pattern.
- The power source mode changes depending on depression of the brake pedal*1 or clutch pedal*2 and the shift lever position*1.
|
Start Function
| Engine Immobiliser
| The engine immobiliser function compares the ID code registered in the smart key ECU assembly, steering lock ECU and the immobiliser code ECU*3 with the ID code of the transponder chip embedded in the key.
|
Steering Lock
| The steering lock function is operated to lock and unlock the steering wheel by using a lock/unlock motor in steering column assembly.
|
Entry Function
| Entry Unlock: The doors unlock if a front door handle assembly outside is gripped.
- The driver or passenger front door handle assembly outside unlocks the all doors.*4,*5
- On the driver side, only the driver's door unlocks, while on the passenger side, all doors unlock. The customization function can be used to set this to unlock the all door.*6,*7
Entry Lock:
- Touching the lock sensor of a front door handle assembly outside will cause all doors to lock.
|
Entry Function
| Luggage Door Open
| The luggage door open function can be operated manually by simply pressing the back door opener switch.
|
Wireless Door Lock Control
| The wireless door lock control function is a convenient system for locking and unlocking all the doors and luggage door at a distance. The basic operation is the same as that in the wireless door lock control system.
|