DIFFERENTIAL SYSTEM > GENERAL



OUTLINE
  1. The rear differential has been designed in accordance with model FD20A rear differential and model FD20AT torque-sensitive limited slip differential (torsen LSD) specifications respectively.

  2. A conical spring (pre-torque mechanism) has been adopted in the differential for model FD20A, improving startability on roads with low μ.

  3. Low-viscosity multi-grade oil has been adopted for FD20A and FD20AT differentials to lower resistance to stirring and bearing rolling resistance, out of concern for reducing fuel consumption.

  4. Traction loss has been reduced by optimizing differential limitation power with model FD20AT, improving vehicle controllability.

  5. A lightweight carrier with optimized thickness and a streamlined rib is used.

  6. For the FD20A and FD20AT type rear differential, lightweight has been achieved by reducing the thickness of the rear differential carrier cover, and by changing the thickness of its ribs.

  7. High-efficient tapered roller bearing is used for the rear drive pinion rear tapered roller bearing to reduce friction loss, thus improving fuel consumption.



  8. For the M/T vehicle, the final gear ratio was set to 4.3 to improve acceleration performance.*

    HINT:
    *: Models for Australia and New Zealand package.


    X110969E01


    Text in Illustration 
    *A
    FD20A Type Differential
    *B
    FD20AT Type Differential
    *1
    Differential Drive Pinion
    *2
    Differential Mount
    *3
    High-efficient Tapered Roller Bearing
    *4
    Differential Ring Gear
    *a
    Lightweight Carrier
    *b
    Differential Pre-torque Mechanism
    *c
    Lightweight Carrier Cover
    -
    -


SPECIFICATION

Grade
BASE
HIGH
Transmission Type
6MT
6AT
6MT
6AT
Differential Type
FD20AT
FD20A
FD20AT*3
FD20AT
←
Gear Type
Hypoid Gear
←
←
←
←
Differential Gear Ratio
4.100*2/4.300*3
4.100
←
4.100*2/4.300*3
4.100
Drive Pinion
No. of Teeth
10
←
←
←
←
Ring Gear
No. of Teeth
41*2/43*3
41
←
41*2/43*3
41
No. of Differential Pinion
8
2
8
←
←
Oil Viscosity
SAE 75W-85
←
←
←
←
Oil Grade
API GL-5
←
←
←
←
Oil Type
TOYOTA Genuine Differential Gear Oil LX
TOYOTA Genuine Differential Gear Oil LT
TOYOTA Genuine Differential Gear Oil LX
←
←
Oil Capacity
Liters (US qts, Imp. qts)
1.15
(1.22, 1.01)
←
←
←
←
Weight (Reference)*1
kg (lb)
33.8
(74.5)
31.5
(69.4)
33.8
(74.5)
←
←
  1. *1: The figure shown is the weight of the part with fluid.
  2. *2: Except models for Australia and New Zealand package.
  3. *3: Models for Australia and New Zealand package.

HINT:
  1. FD20AT torque-sensitive limited slip differential (torsen LSD) equipped vehicles.
  2. Never apply drive power when only one rear wheel has contact with the road, and never spin a single wheel in order to perform on-the-car wheel balancing. Drive power is transferred to the other side of the stopped wheel through the torsen LSD structurally, and this may cause the vehicle to lurch forward suddenly. It also exerts stress on the differential mechanism and may result in damage.
  3. Use the same type and size of wheel and tire on both rear wheels, and use tires with minimal variance in diameter between left and right caused by wear.