COOLING SYSTEM > DETAILS



CONSTRUCTION


  1. Water Pump Assembly

    1. Oil pan sub-assembly has been installed in the engine water pump assembly to drive the fan and generator V belt.



    2. The system has been made more compact by the adoption of small-diameter bearings.


      W108182E01


      Text in Illustration 
      *1
      Water Pump Assembly
      *2
      Oil Pan Sub-assembly
      *3
      Volute Chamber
      *4
      Rotor
      *a
      Cross Section
      *b
      from Radiator Assembly
      *c
      to Cylinder Block Sub-assembly RH
      *d
      from Bottom Bypass Line
      *e
      to Cylinder Block LH
      *f
      Water Flow



  2. Radiator Assembly

    1. A cross flow type radiator is used.

    2. A lightweight, high-performance aluminum-core radiator has been adopted to improve cooling performance and reduce weight.



    3. A lower vehicle height has been achieved by tilting the radiator at an angle of 17 degrees.


      W108183E01


      Text in Illustration 
      *1
      Radiator Assembly
      *2
      Cooler Condenser Assembly
      V100135
      Engine Front
      -
      -