Component
| Function
|
Key
| The transponder (communication chip IC) installed inside the key sends its ID code to the door control receiver.
|
Door Control Receiver
| Sends the ID code received from the key to the smart key ECU assembly.
|
Smart Key ECU Assembly
| Compares the ID code received from the door control receiver with the previously registered ID code and sends the comparison results to the ECM*1 or the immobiliser code ECU*2.
|
Immobiliser Code ECU*2
| Sends the comparison results received from the smart key ECU assembly to the ECM.
|
ECM
| Compares the ID code received from the smart key ECU assembly*1 or the immobiliser code ECU*2 with the previously registered ID code and permits engine startup if the comparison proceeds normally.
|
Push Start Switch
| This is used when the key's battery is low, or similar conditions.
|
Main Body ECU (Network Gateway ECU)
| Blinks or turns off the security indicator light.
|
Combination Meter Assembly
| Is equipped with a security indicator light.
|
Steering Lock Actuator Assembly
| Sends the previously registered ID code to the smart key ECU assembly. Receives the signal from the smart key ECU assembly and locks or unlocks the steering wheel.
|