Home › Brake › BRAKE (FRONT) › FRONT BRAKE

FRONT BRAKE > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



3. DISCONNECT NO. 1 FRONT FLEXIBLE HOSE


    C256621
  1. Remove the union bolt, 2 gaskets and disconnect the No. 1 front flexible hose from the disc brake cylinder assembly LH.



4. REMOVE FRONT DISC BRAKE CYLINDER SUB-ASSEMBLY


    C256645
  1. Remove the 2 bolts and front disc brake cylinder sub-assembly.



5. REMOVE FRONT DISC BRAKE PAD
  1. Remove the disc brake pads from the carrier.



  1. Remove the covers (shims) and shims from each pad.


    C256646E01


    Text in Illustration 
    *1
    Cover (shim)
    *2
    Shim
    *3
    Disc Brake Pad
    -
    -



6. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE (UPPER)


    C261014
  1. Remove the front disc brake pad support plate (upper) from the carrier.



7. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE (LOWER)


    C261015
  1. Remove the front disc brake pad support plate (lower) from the carrier.



8. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN


C261016
  1. Remove the front disc brake cylinder slide pin from the carrier.



9. REMOVE NO. 2 FRONT DISC BRAKE CYLINDER SLIDE PIN


    C261017
  1. Remove the No. 2 front disc brake cylinder slide pin from the carrier.



10. REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSH


    C261018
  1. Remove the 2 front disc brake cylinder slide bushes from the carrier.



11. REMOVE BUSH


    C199487E02
  1. Using a screwdriver with its tip wrapped in protective tape, remove the bush from the pin (B).
    Text in Illustration 
    *1
    Protective Tape



12. REMOVE CARRIER


    C257510
  1. Remove the 2 bolts and carrier.



13. REMOVE FRONT DISC


    C184280E03
  1. Place matchmarks on the front disc and front axle hub.

    HINT:
    It is not necessary when replacing the disc.

    Text in Illustration 
    *a
    Matchmark

  1. Remove the front disc.