Home › Brake › BRAKE (FRONT) › FRONT BRAKE

FRONT BRAKE > DISASSEMBLY

for Preparation Click here




1. REMOVE CYLINDER BOOT


    C256661E01
  1. Remove the 2 cylinder boots.

    NOTICE:
    To prevent damage to the front disc brake piston, remove the boot by hand, and not using a screwdriver or the like.

    Text in Illustration 
    *1
    Cylinder Boot
    *2
    Front Disc Brake Piston



2. REMOVE FRONT DISC BRAKE PISTON


    C256660E01
  1. Place a wooden block between the front disc brake piston and disc cylinder.
    Text in Illustration 
    *1
    Wooden Block
    *a
    30 mm (1.811 in.)

  1. Slowly apply compressed air to remove the 2 front disc brake pistons from the cylinder.

    CAUTION:
    Do not place your fingers in front of the front disc brake piston when applying compressed air.

    NOTICE:
    Do not spatter the brake fluid.

    HINT:
    If the front disc brake piston has been damaged, replace it with a new one.

  1. Remove the wooden block.



3. REMOVE PISTON SEAL


    C256662E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the 2 piston seals from the disc brake cylinder.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Do not damage the inner surface or piston seal groove of the cylinder.



4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
  1. Remove the front disc brake bleeder plug cap from the front disc brake bleeder plug.



5. REMOVE FRONT DISC BRAKE BLEEDER PLUG
  1. Remove the front disc brake bleeder plug.