Home › Brake › BRAKE (FRONT) › FRONT BRAKE

FRONT BRAKE > REASSEMBLY

for Preparation Click here




1. TEMPORARILY INSTALL FRONT DISC BRAKE BLEEDER PLUG
  1. Temporarily install the front disc brake bleeder plug to the front disc brake cylinder assembly LH.



2. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP
  1. Install the front disc brake bleeder plug cap on the front disc brake bleeder plug.



3. INSTALL PISTON SEAL


    C259982
  1. Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new piston seals.
    Text in Illustration 
    V100144
    Lithium Soap Base Glycol Grease

  1. Securely install the 2 piston seals into the grooves of the disc brake cylinder.

    NOTICE:
    Securely install the piston seal into the groove of the disc brake cylinder.



4. INSTALL FRONT DISC BRAKE PISTON


    C259983E01
  1. Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot as shown in the illustration.
    Text in Illustration 
    *1
    Cylinder Boot
    *2
    Front Disc Brake Piston
    V100144
    Lithium Soap Base Glycol Grease

  1. Securely install the cylinder boot into the grooves of the front disc brake piston.

  1. Apply a light of lithium soap base glycol grease to the entire circumference of the 2 front disc brake pistons and install them to the front disc brake cylinder LH.

    NOTICE:
    Do not install the piston forcibly in the disc brake cylinder.



5. INSTALL CYLINDER BOOT


  1. Securely install the cylinder boot into the groove of the front disc brake cylinder LH.


    C256664E01


    Text in Illustration 
    *1
    Cylinder Boot
    *2
    Front Disc Brake Cylinder Assembly LH
    *3
    Front Disc Brake Piston
    -
    -