Home › Brake › BRAKE (REAR) › REAR BRAKE

REAR BRAKE > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for RH and LH sides.
  2. The procedure listed below is for LH side.



1. REMOVE REAR WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



3. DISCONNECT REAR FLEXIBLE HOSE LH


    C261023E01
  1. Remove the union bolt and 2 gaskets and disconnect the rear left flexible hose from the rear disc brake cylinder assembly LH.
    Text in Illustration 
    *A
    Solid Disc Brake
    *B
    Ventilated Disc Brake



4. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH


    C256649
  1. Remove the 2 bolts and rear disc brake cylinder LH.



5. REMOVE REAR DISC BRAKE PAD KIT


    C261024E01
  1. Remove the rear disc brake pad kit from the caliper support bracket.
    Text in Illustration 
    *A
    Solid Disc Brake
    *B
    Ventilated Disc Brake



6. REMOVE REAR DISC BRAKE ANTI SQUEAL SHIM KIT


    C261025E01
  1. Remove the rear disc brake anti squeal shim kit from each rear disc brake pad.
    Text in Illustration 
    *A
    Solid Disc Brake
    *B
    Ventilated Disc Brake
    *1
    Rear Disc Brake Pad
    *2
    Rear Disc Brake Anti Squeal Shim Kit



7. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE


    C256651
  1. Remove the 2 rear disc brake pad support plates.



8. REMOVE CALIPER SUPPORT BRACKET


    C259998
  1. Remove the 2 bolts and caliper support bracket.



9. REMOVE REAR DISC


    C186060E02
  1. Place matchmarks on the rear disc and rear axle hub.
    Text in Illustration 
    *a
    Matchmark

    HINT:
    It is not necessary when replacing the rear disc.



    C256659E01
  1. Release the parking brake and remove the rear disc.

    HINT:
    If it is difficult to remove the rear disc, insert a screwdriver through the hole of rear disc and turn the adjusting screw to contract it.

    Text in Illustration 
    *a
    Contract
    *b
    Expand



10. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
  1. Remove the parking brake shoe adjusting hole plug from the rear from the rear disc.



11. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN


    C261026
  1. Remove the rear disc brake cylinder slide pin from the caliper support bracket.



12. REMOVE REAR DISC BRAKE REAR CYLINDER SLIDE PIN


    C261027
  1. Remove the rear disc brake rear cylinder slide pin from the caliper support bracket.



    C261028
  1. Remove the bush from the rear disc brake rear cylinder slide pin.



13. REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSH


    C261029
  1. Remove the 2 rear disc brake cylinder slide bushes from the caliper support bracket.