Home › Brake › BRAKE (REAR) › REAR BRAKE

REAR BRAKE > DISASSEMBLY

for Preparation Click here




1. REMOVE REAR DISC BRAKE PISTON


    C256666E01
  1. Place a wooden block between the rear disc brake piston and disc brake cylinder.
    Text in Illustration 
    *1
    Wooden Block
    *a
    30 mm (1.1811 in.)

  1. Slowly apply compressed air to remove the disc brake piston.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.

    NOTICE:
    Do not spatter brake fluid.



2. REMOVE CYLINDER BOOT


    C256668E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the cylinder boot from the disc brake cylinder.

    NOTICE:
    Do not damage the inner surface or groove of the cylinder.

    Text in Illustration 
    *1
    Protective Tape



3. REMOVE PISTON SEAL


    C256667E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the piston seal.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Do not damage the inner surface or piston seal groove of the cylinder.



4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP
  1. Remove the rear disc brake bleeder plug cap from the rear disc brake bleeder plug.



5. REMOVE REAR DISC BRAKE BLEEDER PLUG
  1. Remove the rear disc brake bleeder plug from the rear disc brake cylinder assembly LH.