Home › Brake › BRAKE (REAR) › REAR BRAKE

REAR BRAKE > REASSEMBLY

for Preparation Click here




1. TEMPORARILY INSTALL REAR DISC BRAKE BLEEDER PLUG
  1. Temporarily install the rear disc brake bleeder plug to the rear disc brake cylinder LH.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



2. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP
  1. Install the rear disc brake bleeder plug cap to the rear disc brake bleeder plug.



3. INSTALL PISTON SEAL


    C219154
  1. Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal and install it into the groove of the disc brake cylinder.
    Text in Illustration 
    V100144
    Lithium Soap Base Glycol Grease



4. INSTALL CYLINDER BOOT


    C262307E01
  1. Apply a light layer of lithium soap base glycol grease to a new cylinder boot, and put it on the disc brake piston as shown in the illustration.
    Text in Illustration 
    *1
    Piston
    *2
    Cylinder Boot
    V100144
    Lithium soap base glycol grease



5. INSTALL REAR DISC BRAKE PISTON


    C256670E01
  1. Fit the seal section of the cylinder boot into the groove of the rear disc brake cylinder assembly LH.
    Text in Illustration 
    *1
    Cylinder Boot
    *2
    Rear disc Brake Piston
    *3
    Rear disc Brake Cylinder Assembly LH

    NOTICE:
    Securely fit the seal section of the cylinder boot.

  1. Push in the piston by hand and fit the seal section of the boot into the groove of the rear disc brake piston.

    NOTICE:
    Securely fit the seal section of the cylinder boot.