FRONT BRAKE FLEXIBLE HOSE > INSTALLATION |
| 1. INSTALL NO. 1 FRONT FLEXIBLE HOSE |
Temporarily install the NO. 1 front flexible hose with a new clip.
Hold the NO. 1 front flexible hose with a wrench using a union nut wrench.
Connect the No. 1 front flexible hose to the front shock absorber assembly with the bolt.
Install the No. 1 flexible hose to the disc brake cylinder assembly with 2 new gaskets and the new union bolt.
| 2. ADD BRAKE FLUID |
Remove the brake master cylinder reservoir filler cap.
Fill the reservoir with brake fluid.
| 3. BLEED BRAKE LINE |
![]() |
Connect a vinyl tube to the bleeder plug.
Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.*1
When fluid stops coming out, tighten the bleeder plug and release the brake pedal.*2
Repeat steps *1 and *2 until all the air in the brake fluid is completely bled out and a new brake fluid comes out.
Tighten the bleeder plug completely.
Repeat the above steps to replace the brake fluid of the brake lines for each wheel.
| 4. INSPECT BRAKE FLUID LEAK |
| 5. INSPECT FLUID LEVEL |
![]() |
Check the fluid level.
| *a | MAX Line |
| *b | MIN Line |
| 6. INSTALL FRONT WHEEL |