Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE

REAR BRAKE FLEXIBLE HOSE > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for RH and LH sides.
  2. The procedure listed below is for LH side.



1. INSTALL REAR LEFT FLEXIBLE HOSE
  1. Connect the rear left flexible hose with a new clip.

    NOTICE:
    Securely install the clip.

  1. Hold the rear left flexible hose with a wrench and connect the brake tube to the rear left flexible hose using a union nut wrench.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    1. Do not bend or damage the brake tube.
    2. Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting position.
    3. Use the formula to calculate special torque wrench is combined with a torque wrench (Click here).

  1. Connect the rear left flexible hose to the rear carrier LH with the bolt.

    Torque:
    33 N*m{ 337 kgf*cm , 24 ft.*lbf }

  1. Connect the rear left flexible hose to the rear disc brake cylinder assembly LH with a new 2 gaskets and the new union bolt.

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }



2. ADD BRAKE FLUID
  1. Remove the brake master cylinder reservoir filler cap.

  1. Fill the reservoir with brake fluid.

    Brake Fluid:
    SAE J1703 or FMVSS No. 116 DOT 3

    NOTICE:
    Make sure that there is sufficient brake fluid in the reservoir.



3. BLEED BRAKE LINE


C256648

NOTICE:
  1. Bleed the brake line of the wheel farthest from the master cylinder first.
  2. Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brake lines.

  1. Connect a vinyl tube to the bleeder plug.

  1. Depress the brake pedal several times, and then loosen the bleeder plug with the pedal depressed.*1

  1. When fluid stops coming out, tighten the bleeder plug and release the brake pedal.*2

  1. Repeat steps *1 and *2 until all the air in the brake fluid is completely bled out and a new brake fluid comes out.

  1. Tighten the bleeder plug completely.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Repeat the above steps to replace the brake fluid of the brake lines for each wheel.



4. INSPECT BRAKE FLUID LEAK


5. INSPECT FLUID LEVEL


    C259961E01
  1. Check the fluid level.
    Text in Illustration 
    *a
    MAX Line
    *b
    MIN Line
    If brake fluid level is lower than the MIN line, check for leaks and inspect the disc brake pads. If necessary, refill the reservoir with brake fluid to the MAX line after repair or replacement.

    Brake Fluid:
    SAE J1703 or FMVSS No. 116 DOT 3

    NOTICE:
    If using a dropper to adjust the fluid amount, make sure that the dropper has not been used with mineral oils, water or deteriorated brake fluid. Sealed areas may deteriorate and lead to fluid leaks, or the fluid may deteriorate and lead to decreased efficiency.



6. INSTALL REAR WHEEL

Torque:
120 N*m{ 1224 kgf*cm , 88 ft.*lbf }