STARTER (for Automatic Transmission) > DISASSEMBLY |
| 1. REMOVE MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Remove the nut and disconnect the lead wire from terminal C.
![]() |
Remove the 2 nuts and the magnet starter switch assembly from the starter drive housing assembly.
| 2. REMOVE STARTER YOKE ASSEMBLY |
![]() |
Using a "TORX" socket wrench T25, remove the 2 through bolts.
![]() |
Remove the starter yoke assembly and starter cover from the starter drive housing assembly.
| 3. REMOVE STARTER COVER |
![]() |
Remove the 2 screws.
![]() |
Remove the starter cover from the starter yoke assembly.
| *1 | Starter Yoke Assembly |
| *2 | Starter Cover |
Remove the dust starter protect from the starter yoke assembly.
| 4. REMOVE STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Using a screwdriver, disengage the spring from the bush.
Disconnect the 4 brush from the starter brush holder assembly.
Remove the starter brush holder assembly.
| 5. REMOVE STARTER ARMATURE ASSEMBLY |
![]() |
Pull out the starter armature assembly from the starter yoke assembly.
| *1 | Starter Yoke Assembly |
| *2 | Starter Armature Assembly |
| 6. REMOVE STARTER ARMATURE PLATE |
![]() |
Remove the starter armature plate from the starter yoke assembly and starter drive housing assembly.
| *1 | Starter Drive Housing Assembly |
| *2 | Starter Yoke Assembly |
| *3 | Starter Armature Plate |
| 7. REMOVE RUBBER SEAL |
![]() |
Remove the rubber seal from the starter drive housing assembly.
| *1 | Rubber Seal |
| 8. REMOVE STARTER PLANETARY GEAR |
![]() |
Remove the 3 starter planetary gears from the starter clutch sub-assembly.