Home › Engine / Hybrid System › FA20 STARTING › STARTER (for Manual Transmission)

STARTER (for Manual Transmission) > DISASSEMBLY

for Preparation Click here



1. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    A281409
  1. Remove the nut and disconnect the lead wire from terminal C.



    A281410
  1. Remove the 2 screws and the magnet starter switch assembly from the starter drive housing assembly.



2. REMOVE STARTER COVER


    A281411
  1. Remove the 2 through bolts and 2 screws, and remove the starter cover.



3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    A281412
  1. Remove the starter brush holder assembly.

    HINT:
    Hold the brush with your fingers so that the brush spring does not come flying out.



4. REMOVE STARTER YOKE ASSEMBLY


    A281413
  1. Remove the starter yoke assembly and starter armature assembly together from the starter drive housing assembly.



5. REMOVE STARTER ARMATURE ASSEMBLY


    A281414
  1. Pull out the starter armature assembly from the starter yoke assembly.



6. REMOVE STARTER HOUSING RUBBER


    A281416E01
  1. Remove the starter housing rubber, seal rubber and plate from the starter drive housing assembly.
    Text in Illustration 
    *1
    Starter Housing Rubber
    *2
    Plate
    *3
    Seal Rubber



7. REMOVE STARTER PLANETARY GEAR


    A281408
  1. Remove the 3 starter planetary gears from the starter clutch sub-assembly.



8. REMOVE STARTER CLUTCH SUB-ASSEMBLY


    A281417
  1. Remove the starter clutch sub-assembly together with the drive lever set pin from the starter drive housing assembly.



    A278479E01
  1. Using a 14 mm deep socket wrench, remove the stopper from snap ring.
    Text in Illustration 
    *1
    14 mm Deep Socket Wrench
    *2
    Stopper
    *3
    Snap Ring



    A281418
  1. Using snap ring pliers, remove the snap ring and stopper.



    A281419
  1. Pull out the over running clutch from the shaft.



    A281420E01
  1. Remove the internal gear assembly from the shaft.
    Text in Illustration 
    *1
    Internal Gear Assembly
    *2
    Shaft