Home › Engine / Hybrid System › FA20 STARTING › STARTER (for Automatic Transmission)

STARTER (for Automatic Transmission) > REASSEMBLY

for Preparation Click here



1. INSTALL STARTER PLANETARY GEAR


A282563
  1. Apply high-temperature grease to the planetary gears and pins of the planetary shaft.

  1. Install the 3 starter planetary gears.
    Text in Illustration 
    V100135
    High-temperature Grease



2. INSTALL RUBBER SEAL


    A281407E01
  1. Install the rubber seal to the starter drive housing assembly.
    Text in Illustration 
    *1
    Rubber Seal



3. INSTALL STARTER ARMATURE ASSEMBLY


    A281405E01
  1. Install the starter armature assembly to the starter yoke assembly.
    Text in Illustration 
    *1
    Starter Yoke Assembly
    *2
    Starter Armature Assembly



4. INSTALL STARTER BRUSH HOLDER ASSEMBLY


    A211303
  1. Install the 4 brushes and 4 brush springs.



    A211304
  1. Install the starter brush holder assembly to the starter armature assembly. Push the 4 brushs.



    A194294E01
  1. Insert the grommet between the positive (+) motor read wire and the negative (-) brush holder plate.
    Text in Illustration 
    *1
    Grommet
    *2
    Negative (-) Brush Holder Plate
    *3
    Positive (+) Motor Read Wire



5. INSTALL STARTER COVER
  1. Install the dust starter protector to the starter yoke assembly.



    A190520
  1. Align the starter brush holder assembly read wire rubber with the groove of the starter cover.



    A192615
  1. Install the starter cover to the starter brush holder assembly with 2 screws.

    Torque:
    :
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }



6. INSTALL STARTER ARMATURE PLATE
  1. Align the claw of the starter yoke assembly with the groove the starter armature plate.



  1. Install the starter armature plate to the starter yoke assembly.


    A187232E02


    Text in illustration 
    *1
    Claw
    *2
    Groove



7. INSTALL STARTER YOKE ASSEMBLY


    A172145E03
  1. Align the claw of the starter yoke assembly with the groove inside the starter drive housing assembly.
    Install the starter yoke assembly together with the starter armature assembly to the starter drive housing assembly.
    Text in Illustration 
    *1
    Claw
    *2
    Groove



    A280973
  1. Using a "TORX" socket wrench T25, install the 2 through bolts.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }



8. INSTALL MAGNET STARTER SWITCH ASSEMBLY


    A281422
  1. Apply high-temperature grease to the plunger and hook as shown in the illustration.
    Text in Illustration 
    V100135
    High-temperature grease



    A156359E02
  1. Hook the plunger and hook of the magnet starter switch assembly to the lever of the starter drive housing assembly.
    Text in Illustration 
    *1
    Plunger and Hook
    *2
    Lever



    A280972
  1. Install the magnet starter switch assembly with the 2 screws.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



    A280971
  1. Connect the lead wire to terminal C with the nut.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }