Home › Engine / Hybrid System › FA20 STARTING › STARTER (for Manual Transmission)

STARTER (for Manual Transmission) > REASSEMBLY

for Preparation Click here



1. INSTALL STARTER CLUTCH SUB-ASSEMBLY


    A281840
  1. Apply high-temperature grease to the shaft as shown in the illustration.
    Text in Illustration 
    V100145
    High-temperature Grease



    A281420
  1. Install the internal gear to the shaft.



    A281841
  1. Apply high-temperature grease to the shaft as shown in the illustration.
    Text in Illustration 
    V100145
    High-temperature Grease



    A281419
  1. Install the over running clutch to the shaft.



    A281418
  1. Install the stopper to the shaft.
    Using snap ring pliers, install the snap ring.



    A278481E01
  1. Using a press, press the snap ring into the stopper.
    Text in Illustration 
    *1
    Snap Ring
    *2
    Stopper



    A281417
  1. Install the starter clutch sub-assembly together with the drive lever set pin to the starter drive housing assembly.



2. INSTALL STARTER PLANETARY GEAR


A281415
  1. Apply high-temperature grease to the planetary gears and pins of the planetary shaft.

  1. Install the 3 starter planetary gears.
    Text in Illustration 
    V100135
    High-temperature Grease



3. INSTALL STARTER HOUSING RUBBER


    A281416E01
  1. Install the starter housing rubber, seal rubber and plate to the starter drive housing assembly.
    Text in Illustration 
    *1
    Starter Housing Rubber
    *2
    Plate
    *3
    Seal Rubber



4. INSTALL STARTER ARMATURE ASSEMBLY


    A281414
  1. Install the starter armature assembly to the starter yoke assembly.



5. INSTALL STARTER YOKE ASSEMBLY


    A281423E01
  1. Align the claw of the starter yoke assembly with the groove inside the starter drive housing assembly.
    Text in Illustration 
    *1
    Claw
    *2
    Groove



    A281413
  1. Install the starter yoke assembly together with the starter armature assembly to the starter drive housing assembly.



6. INSTALL STARTER BRUSH HOLDER ASSEMBLY


    A281424
  1. Install a 24 mm socket to the starter brush holder assembly.

  1. Install the starter brush holder assembly to the starter armature assembly.



7. INSTALL STARTER COVER


    A281411
  1. Install the starter cover with 2 screws and 2 bolts.

    Torque:
    Bolt:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }
    Screw:
    1.4 N*m{ 14 kgf*cm , 12 in.*lbf }



8. INSTALL MAGNET STARTER SWITCH ASSEMBLY


    A281410
  1. Install the magnet starter switch assembly with the 2 screws.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



    A281409
  1. Connect the lead wire to terminal C with the nut.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }