Home › Engine / Hybrid System › FA20 ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL



2. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap, cylinder block drain cock plugs and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the local regulations.



    A277916
  1. Remove the service hole cover from the front bumper under cover.

  1. Connect a hose with an inside diameter of 8 mm (0.315 in.) to the drain plug.



    A277917
  1. Loosen the radiator drain cock plug.



    A279728
  1. Open the air bleed plug on the heater hose side. (for LHD)



    A279727
  1. Open the air bleed plug on the heater hose side. (for RHD)

  1. Remove the radiator cap and drain the coolant.



3. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    A283417
  1. Loosen the hose clamp and disconnect the No. 2 ventilation hose.



    A283418
  1. Disconnect the mass air flow meter connector.

  1. Disengage the clamp and separate the wire harness from the air cleaner cap.



    A283419
  1. Loosen the 2 hose clamps.



    A283420
  1. Remove the 3 bolts and the air cleaner cap with air cleaner hose.



4. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY


    A276526
  1. Disconnect the throttle with motor body assembly connector.



    A276527
  1. Disconnect the 2 water by-pass hoses from the throttle with motor body assembly.



    A276528
  1. Remove the 4 bolts and the throttle with motor body assembly from the intake manifold.

  1. Remove the gasket from the intake manifold.