Home › Engine / Hybrid System › FA20 ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR



A281847E01


Text in Illustration 
*1
Resistance
*2
Temperature
*3
Acceptable
-
-
*a
Component without harness connected
(Engine Coolant Temperature Sensor)
-
-
  1. Partially soak the sensor in the water and warm up the water.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Approximately. 20°C (68°F)
    2.35 to 2.65 kΩ
    Approximately. 80°C (176°F)
    0.305 to 0.331 kΩ

    NOTICE:
    When checking the engine coolant temperature sensor in water, keep the terminals dry. After the check, wipe the engine coolant temperature sensor dry.

    If the result is not as specified, replace the engine coolant temperature sensor.