Home › Engine / Hybrid System › FA20 ENGINE CONTROL › ENGINE OIL TEMPERATURE SENSOR

ENGINE OIL TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE OIL TEMPERATURE SENSOR



A224572E02


Text in Illustration 
*a
Resistance
*b
Temperature
*c
Acceptable
*d
Component without harness connected
(Engine oil Temperature Sensor)
  1. Partially soak the sensor in the water and warm up the water.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Approximately 20°C (68°F)
    2.25 to 2.65 kΩ
    Approximately 80°C (176°F)
    0.305 to 0.331 kΩ

    NOTICE:
    When checking the engine oil temperature sensor in water, keep the terminals dry. After the check, wipe the engine oil temperature sensor dry.

    If the result is not as specified, replace the engine oil temperature sensor.