Home › Engine / Hybrid System › FA20 INTAKE / EXHAUST › INTAKE MANIFOLD

INTAKE MANIFOLD > REASSEMBLY

for Preparation Click here



1. INSTALL NO. 2 FUEL DELIVERY PIPE SUB-ASSEMBLY


    A391674E01
  1. Install the No. 2 fuel delivery pipe sub-assembly to the intake manifold with the 3 clamps. (for resin intake manifold)

  1. Install the No. 2 fuel delivery pipe sub-assembly to the intake manifold with the 2clamps. (for aluminum intake manifold)
    Text in Illustration 
    *A
    for Resin Intake Manifold
    *B
    for Aluminum Intake Manifold



2. INSTALL FUEL DELIVERY PIPE (for Bank 2)
  1. Apply a gasoline to the contact surfaces of the new O-ring on each fuel injector assembly.

  1. Install a new 2 O-rings to each fuel injector assembly.

  1. Install the fuel injector assembly to the intake manifold with fuel delivery pipe.

    NOTICE:
    1. Do not damage the fuel injector assembly or the O-ring.
    2. Do not twist the O-ring.



    A391671E01
  1. Install the fuel delivery pipe with the 2 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    Text in Illustration 
    *A
    for Resin Intake Manifold
    *B
    for Aluminum Intake Manifold

  1. Check that the fuel injectors rotate smoothly.

    NOTICE:
    If the fuel injectors do not rotate smoothly, the probable cause is incorrect installation of the O-rings. Replace the O-rings.

  1. Position the fuel injector connector outward.



3. INSTALL FUEL DELIVERY PIPE (for Bank 1)

HINT:
Use the same procedure described for the fuel delivery pipe (for bank 2).



4. INSTALL CAP (for Automatic Transmission)


    A285063
  1. Install the cap to the intake manifold.



5. INSTALL PURGE VALVE


    A391668E01
  1. Connect the No. 1 fuel vapor feed hose to the intake manifold.
    Text in Illustration 
    *A
    for Resin Intake Manifold
    *B
    for Aluminum Intake Manifold



    A391669E01
  1. Install the nut and purge valve to the intake manifold.

    Torque:
    6.4 N*m{ 65 kgf*cm , 57 in.*lbf }

    Text in Illustration 
    *A
    for Resin Intake Manifold
    *B
    for Aluminum Intake Manifold



6. INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR
  1. Apply engine oil to the contact surfaces of the new O-ring on manifold absolute pressure sensor.



    A276541
  1. Install a new O-ring to the manifold absolute pressure sensor.



    A391667E01
  1. Install the manifold absolute pressure sensor to the intake manifold with the bolt.

    Torque:
    for Resin Intake Manifold:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }
    for Aluminum Intake Manifold:
    3.4 N*m{ 35 kgf*cm , 30 in.*lbf }

    Text in Illustration 
    *A
    for Resin Intake Manifold
    *B
    for Aluminum Intake Manifold