Home › Engine / Hybrid System › FA20 ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL AIR FUEL RATIO SENSOR


    A276543E01
  1. Using SST, install the air fuel ratio sensor onto the exhaust manifold.

    SST
    09224-00010  

    Torque:
    Without SST:
    21 N*m{ 214 kgf*cm , 16 ft.*lbf }
    With SST:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    If a component has been dropped or subjected to a strong impact, replace it.

    HINT:
    1. This torque value is effective when SST is parallel to the torque wrench.
    2. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    3. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.087 in.).
    4. If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values (Click here).

  1. Engage the 2 clamps.

  1. Connect the air fuel ratio sensor connector.



2. CONNECT BATTERY NEGATIVE TERMINAL



3. INSPECT FOR EXHAUST GAS LEAK
  1. If gas is leaking, tighten the areas necessary to stop the leak. Replace the damaged parts as necessary.