Home › Engine / Hybrid System › FA20 ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR


    A276547E02
  1. Using SST, install the heated oxygen sensor onto the exhaust manifold assembly.

    SST
    09224-00010  

    Torque:
    without SST:
    21 N*m{ 214 kgf*cm , 16 ft.*lbf }
    with SST:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    HINT:
    1. This torque value is effective when SST is parallel to the torque wrench.
    2. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    3. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.087 in.).
    4. If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values (Click here)

  1. Engage the 2 clamps.

  1. Connect the oxygen sensor connector.



2. INSPECT FOR EXHAUST GAS LEAK
  1. If gas is leaking, tighten the areas necessary to stop the leak. Replace the damaged parts as necessary.



3. INSTALL REAR ENGINE UNDER COVER RH
  1. Instal the 3 clips, and connect the engine under cover rear RH.

  1. Install the brake hose bracket mounting bolt.



4. INSTALL NO. 1 ENGINE UNDER COVER


    A280546
  1. Install the No. 1 engine under cover with the 12 bolts and engage the 7 clips.
    V100135
    Bolt A
    V100136
    Bolt B

    Torque:
    Bolt A:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }
    Bolt B:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



5. INSTALL FRONT TIRE