Home › Engine / Hybrid System › FA20 ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSPECTION

for Preparation Click here



1. INSPECT HEATED OXYGEN SENSOR


    A189305E03
  1. Measure the resistance according to the value(s) the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68 °F)
    5.0 to 6.4 Ω
    1 - 4
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Heated Oxygen Sensor)
    If the result is not as specified, replace the heated oxygen sensor.