Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > ADJUSTMENT

for Preparation Click here



1. DISCONNECT TRANSMISSION CONTROL SHAFT LEVER RH
  1. While pushing the shift lock release button, move the shift lever to N.



    C260608
  1. Remove the nut and spring washer, and disconnect the transmission control shaft lever RH.



2. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    D025795E32
  1. Remove the bolt of the park/neutral position switch assembly.

  1. Clean the bolt and the bolt hole.



    A057108E21
  1. Apply adhesive to 2 or 3 threads on the end of the bolt.
    Text in Illustration 
    *1
    Adhesive

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



    D025795E28
  1. Align the neutral basic line with the groove as shown in the illustration.
    Text in Illustration 
    *a
    Neutral Basic Line
    *b
    Groove

  1. Hold the park/neutral position switch assembly in position and install the bolt.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }



3. CONNECT TRANSMISSION CONTROL SHAFT LEVER RH
  1. Connect the transmission control shaft lever RH with the spring washer and nut.

    Torque:
    16 N*m{ 160 kgf*cm , 12 ft.*lbf }



4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Apply the parking brake and turn the ignition switch to ON.

  1. Depress the brake pedal and check that the engine starts when the shift lever is in N or P, but does not start when the shift lever is in other positions.

  1. Check that the back-up light illuminates and the reverse warning buzzer sounds only when the shift lever is in R.
    If a malfunction failure is found, check the park/neutral position switch assembly for continuity.