Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › OIL COOLER

OIL COOLER > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A278294
  1. Disengage the 7 clips and remove the 12 bolts and No. 1 engine under cover.



2. REMOVE NO. 2 ENGINE UNDER COVER


    A278295
  1. Remove the 7 bolts and the No. 2 engine under cover.



3. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator cap, cylinder block drain cock plugs and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the local regulations.



    A277916
  1. Remove the service hole cover from the front bumper under cover.

  1. Connect a hose with an inside diameter of 8 mm (0.315 in.) to the drain plug.



    A277917
  1. Loosen the radiator drain cock plug.



    A279728
  1. Open the air bleed plug on the heater hose side. (for LHD)



    A279727
  1. Open the air bleed plug on the heater hose side. (for RHD)

  1. Remove the radiator cap and drain the coolant.



4. DISCONNECT TRANSMISSION OIL COOLER HOSE


    C264290
  1. Loosen the 2 hose clamps and disconnect the 2 oil cooler hoses from the transmission oil cooler.

    NOTICE:
    Use a container to catch any coolant which flows out of the oil cooler hoses.



5. DISCONNECT WATER BY-PASS HOSE


    C258481
  1. Loosen the 2 hose clamps and disconnect the 2 water by-pass hoses.

    NOTICE:
    Use a container to catch any coolant which flows out of the water by-pass hoses.



6. REMOVE TRANSMISSION OIL COOLER ASSEMBLY


    C258482
  1. Remove the 3 bolts and the transmission oil cooler.



    C264500
  1. Loosen the 2 hose clamps and remove the 2 oil cooler hoses from the transmission oil cooler.

  1. Remove the clip from the oil cooler hoses.



    C260611
  1. Remove the 2 bolts and the transmission oil cooler from the transmission oil cooler bracket.