Home › Drivetrain · TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION WIRE

TRANSMISSION WIRE > INSPECTION

for Preparation Click here



1. INSPECT ATF TEMPERATURE SENSOR (TRANSMISSION WIRE)


    C214326E11
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (ATF Temperature Sensor (Transmission Wire))

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (E2) - 9 (OIL)
    Always
    79 Ω to 156 kΩ
    1 (E2) - Body ground
    Always
    10 kΩ or higher
    9 (OIL) - Body ground
    Always
    10 kΩ or higher

    HINT:
    If the resistance is out of the specified range at any of the ATF temperatures shown in the table below, the driveability of the vehicle may decrease.

    Standard Resistance:
    ATF Temperature
    Specified Condition
    10°C (50°F)
    5 to 8 kΩ
    25°C (77°F)
    2.5 to 4.5 kΩ
    110°C (230°F)
    0.22 to 0.28 kΩ

    If the result is not as specified, replace the ATF temperature sensor (transmission wire).