Home › Drivetrain · TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER

SHIFT LEVER > INSPECTION

for Preparation Click here



1. INSPECT TRANSMISSION CONTROL SWITCH (SHIFT LEVER ASSEMBLY)


    A280138E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Transmission Control Switch (Shift Lever Assembly))

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 3
    Shift lever not in P
    Below 1 Ω
    2 - 3
    Shift lever in P
    8 - 9
    Shift lever in M
    Shift lever held in "+"
    (Up shift)
    10 - 11
    Shift lever in M
    12 - 13
    Shift lever in M
    Shift lever held in "-"
    (Down shift)
    1 - 3
    Shift lever in P
    10 kΩ or higher
    2 - 3
    Shift lever not in P
    8 - 9
    Shift lever in M
    Shift lever not in "+"
    10 - 11
    Shift lever not in M
    12 - 13
    Shift lever in M
    Shift lever not in "-"

    If the result is not as specified, replace the transmission control switch.



2. INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY (SHIFT LEVER ASSEMBLY)


    A280138E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Shift Lock Control Unit Assembly)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    4 - 5
    20°C (68°F)
    27.6 to 30.5 Ω

    If the result is not as specified, replace the shift lock control unit assembly.