Home › Drivetrain · TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › PATTERN SELECT SWITCH

PATTERN SELECT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT PATTERN SELECT SWITCH ASSEMBLY


    C261041E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Pattern Select Switch Assembly)

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 - 8
    Pattern select (SNOW) switch on
    Below 1 Ω
    Pattern select (SNOW) switch off
    10 kΩ or higher
    4 - 8
    Pattern select (SPORT) switch on
    Below 1 Ω
    Pattern select (SPORT) switch off
    10 kΩ or higher

    If the result is not as specified, replace the pattern select switch assembly.