Home › Drivetrain ยท DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY

REAR DRIVE SHAFT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL REAR DRIVE SHAFT ASSEMBLY LH
  1. Align the rear axle carrier splines and rear drive shaft assembly splines, and install the rear drive shaft assembly.



2. INSTALL REAR AXLE SHAFT NUT LH
  1. Clean the threaded parts on the rear drive shaft assembly and a new rear axle shaft nut using a non-residue solvent.

    NOTICE:
    1. Be sure to perform this step even when using a new rear drive shaft assembly.
    2. Keep the threaded parts free of oil and foreign matter.

  1. Install the new rear axle shaft nut.

    Torque:
    190 N*m{ 1938 kgf*cm , 140 ft.*lbf }

    HINT:
    Stake the rear axle shaft nut LH after inspecting for looseness and runout in the following steps.



3. INSTALL REAR DRIVE SHAFT ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.



4. INSTALL REAR AXLE SHAFT NUT RH

HINT:
Use the same procedure described for the LH side.



5. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
(Click here)