Home › Drivetrain ยท AXLE AND DIFFERENTIAL › FRONT AXLE HUB

FRONT AXLE HUB > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT WHEEL


2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
  1. Remove the 2 bolts and separate the front disc brake caliper assembly from the steering knuckle.

    NOTICE:
    Hang the caliper using a piece of string or equivalent.



3. REMOVE FRONT DISC


    C184280E03
  1. Place matchmarks on the front disc and front axle hub.

    HINT:
    It is not necessary when replacing the disc.

    Text in Illustration 
    *a
    Matchmark

  1. Remove the front disc.



4. DISCONNECT FRONT SPEED SENSOR LH


    C257545
  1. Remove the bolt and disconnect the front speed sensor LH from the steering knuckle.

    NOTICE:
    Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor LH is removed.



5. REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH


    C257511
  1. Remove the 4 bolts and front axle hub sub-assembly LH from the steering knuckle.