Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB

REAR AXLE HUB > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH
  1. Install the rear axle hub and bearing assembly to the rear axle assembly with the 4 bolts.

    Torque:
    65 N*m{ 663 kgf*cm , 48 ft.*lbf }



2. INSTALL REAR DISC
  1. Align the matchmarks placed when removing, install the rear disc to the axle hub.

    HINT:
    When using a new rear disc, install it so that rear disc runout is minimum.



3. INSTALL REAR CALIPER ASSEMBLY
  1. Install the rear disc brake caliper assembly LH with the new 2 bolts.

    Torque:
    66 N*m{ 673 kgf*cm , 49 ft.*lbf }



4. STAKE REAR AXLE SHAFT NUT LH
  1. Clean the threaded parts on the rear drive shaft assembly and a new rear axle shaft nut using a non-residue solvent.

    NOTICE:
    1. Be sure to perform this step even when using a new rear drive shaft assembly.
    2. Keep the threaded parts free of oil and foreign matter.

  1. Install the new rear axle shaft nut.

    Torque:
    190 N*m{ 1938 kgf*cm , 140 ft.*lbf }

    HINT:
    Stake the rear axle shaft nut LH after inspecting for looseness and runout in the following steps.



5. INSPECT REAR AXLE HUB BEARING LOOSENESS


    C259946
  1. Using a dial indicator, check for looseness near the center of the rear axle hub.

    Maximum looseness:
    0.05 mm (0.00196 in.)

    NOTICE:
    1. Make sure that the dial indicator is set perpendicular to the measurement surface.
    2. Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.

    If the looseness is more than the maximum, replace the rear axle hub and bearing assembly.



6. INSPECT REAR AXLE HUB RUNOUT


    C259947
  1. Using a dial indicator, check for runout on the surface of the rear axle hub and bearing assembly outside the rear axle hub bolt.

    Maximum runout:
    0.05 mm (0.00196 in.)

    NOTICE:
    1. Make sure that the dial indicator is set perpendicular to the measurement surface.
    2. Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.

    If the runout is more than the maximum, replace the rear axle hub and bearing assembly.



7. STAKE REAR AXLE SHAFT NUT LH


    C259945
  1. Using a chisel and hammer, stake the rear axle shaft nut LH.



8. INSTALL REAR SPEED SENSOR LH
  1. Install the bolt and the rear speed sensor LH.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



9. INSTALL REAR WHEEL

Torque:
120 N*m{ 1224 kgf*cm , 89 ft.*lbf }



10. ADJUST PARKING BRAKE LEVER TRAVEL
(Click here)


11. INSPECT SPEED SENSOR SIGNAL
(Click here)