Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB

REAR AXLE HUB > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR WHEEL


2. SEPARATE REAR SPEED SENSOR LH


    C257477
  1. Remove the bolt and separate the rear speed sensor LH.

    NOTICE:
    Prevent foreign matter from attaching to the sensor tip.



3. REMOVE REAR AXLE SHAFT NUT LH


C259939
  1. Using SST and a hammer, release the staked part of the rear axle shaft nut.

    SST
    09930-00010  

    NOTICE:
    1. Do not grind the SST.
    2. Release the staked part of the nut completely; otherwise the threads of the drive shaft may get damaged.

  1. Remove the rear axle shaft nut.



4. SEPARATE REAR CALIPER ASSEMBLY


    C256615
  1. Remove the 2 bolts and separate the rear disc brake caliper assembly LH.

    NOTICE:
    Hang the rear disc brake cylinder assembly LH with wire or equivalent.



5. REMOVE REAR DISC


    C186060E02
  1. Place matchmarks on the rear disc and rear axle hub.
    Text in Illustration 
    *a
    Matchmark

    HINT:
    It is not necessary when replacing the rear disc.



    C256659E01
  1. Release the parking brake and remove the rear disc.

    HINT:
    If it is difficult to remove the rear disc, insert a screwdriver through the hole of rear disc and turn the adjusting screw to contract it.

    Text in Illustration 
    *a
    Contract
    *b
    Expand



6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH
  1. Using a plastic-faced hammer, disconnect the rear drive shaft assembly from the rear axle hub and bearing assembly LH.

    NOTICE:
    1. Be careful not to damage the boot.
    2. Use a wire or equivalent to prevent the rear drive shaft assembly from hanging down.



    C259944
  1. Remove the 4 bolts and the rear axle hub and bearing assembly LH from the rear axle assembly.