Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT OIL PUMP OIL SEAL


    C210561E01
  1. Using SST and a hammer, install a new front oil pump oil seal.

    SST
    09350-30020   (09351-32140)

    Drive in depth:
    -0.2 to 0.2 mm (-0.00787 to 0.00787 in.)

  1. Coat the lip of the front oil pump oil seal with MP grease.



2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY
  1. Place the front oil pump body sub-assembly on the torque converter assembly.



3. INSTALL CLUTCH DRUM OIL SEAL RING


    C108579
  1. Coat 3 new clutch drum oil seal rings with ATF.

  1. Squeeze the ends of the 3 clutch drum oil seal rings so that the gap distance becomes 8 mm (0.315 in.) or less, and then install them to the stator shaft groove.

    NOTICE:
    Do not expand the ring ends excessively.

    HINT:
    After installing the clutch drum oil seal rings, check that they rotate smoothly.



4. INSPECT OIL PUMP DRIVE GEAR ROTATION


    C108581
  1. Make sure that the drive gear rotates smoothly.

  1. Remove the oil pump assembly from the torque converter assembly.



5. INSTALL FRONT OIL PUMP BODY O-RING


    D027950E01
  1. Coat a new front oil pump body O-ring with ATF and install it to the oil pump assembly.