Home › Drivetrain ยท CLUTCH › CLUTCH UNIT

CLUTCH UNIT > INSPECTION

for Preparation Click here



1. INSPECT CLUTCH DISC ASSEMBLY


    C258510
  1. Using a vernier caliper, measure the rivet head depth.

    Minimum rivet depth:
    0.3 mm (0.0118 in.)

    If necessary, replace the clutch disc assembly.



    C258511
  1. Install the clutch disc assembly to the manual transmission assembly.

    NOTICE:
    Insert the clutch disc assembly in the correct direction.

  1. Using a dial indicator with a roller instrument, measure the clutch disc assembly runout.

    Maximum runout:
    0.8 mm (0.0315 in.)

    If necessary, replace the clutch disc assembly.



2. INSPECT CLUTCH COVER ASSEMBLY


    C258512E01
  1. Using a vernier caliper, measure the depth and width of the diaphragm spring wear.

    Maximum:
    A (Depth):
    0.5 mm (0.0197 in.)
    B (Width):
    6.0 mm (0.236 in.)

    If necessary, replace the clutch cover assembly.



3. INSPECT FLYWHEEL SUB-ASSEMBLY


    C258513
  1. Using a dial indicator, measure the flywheel sub-assembly runout.

    Maximum runout:
    0.1 mm (0.00394 in.)

    If necessary, replace the flywheel sub-assembly.



4. INSPECT CLUTCH RELEASE BEARING ASSEMBLY


    C127507
  1. Check that the clutch release bearing assembly moves smoothly without abnormal resistance by turning the sliding parts of the clutch release bearing assembly (contact surfaces with the clutch cover) while applying force in the axial direction.

  1. Inspect the clutch release bearing assembly for damage and wear.
    If necessary, replace the clutch release bearing assembly.



5. INSPECT FLYWHEEL BEARING


    C299420
  1. Turn the flywheel bearing by hand while applying rotational force and check that the flywheel bearing rotates smoothly. If the flywheel bearing sticks or a considerable amount of resistance is felt, replace the flywheel bearing.

    HINT:
    The flywheel bearing is permanently lubricated and requires no cleaning or lubrication.



6. REPLACE FLYWHEEL BEARING


    A276036E03
  1. Using SST, hold the crankshaft pulley.

    SST
    09960-10010   (09962-01000, 09963-01000)



    C299423
  1. Remove any 2 diametrically opposite bolts.



    C299421E01
  1. Using SST, remove the flywheel bearing.

    SST
    09303-35011  
    Text in Illustration 
    *a
    Hold
    *b
    Turn



    C299422E01
  1. Using SST and a hammer, tap in a new flywheel bearing.

    SST
    09950-60010   (09951-00340)
    09950-70010   (09951-07150)

    Standard depth:
    0 to 0.4 mm (0 to 0.0158 in.)

    Text in Illustration 
    *a
    Depth from flywheel edge

    NOTICE:
    1. Do not tap in the flywheel bearing at an angle.
    2. Do not tap in the flywheel bearing more than necessary.

    HINT:
    After installing the flywheel bearing, make sure that it rotates smoothly.



    A276036E03
  1. Using SST, hold the crankshaft pulley.

    SST
    09960-10010   (09962-01000, 09963-01000)



    C299423
  1. Install the 2 bolts.

    Torque:
    85 N*m{ 867 kgf*cm , 63 ft.*lbf }