Home › Engine / Hybrid System › FA20 ENGINE CONTROL › SFI SYSTEM

SFI SYSTEM > PRECAUTION

for Preparation Click here



1.INITIALIZATION

NOTICE:
  1. If the ECM is replaced, register the ECU communication ID for Immobiliser System (refer to the registration procedures for Service Bulletin).
  2. Perform Registration (VIN registration) when replacing the ECM (Click here).


2.WHEN USING GTS

CAUTION:
Observe the following items for safety reasons:

  1. Before using the GTS, read the instruction manual.
  2. Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.
  3. When driving the vehicle for testing purposes using the GTS, 2 persons are required. One is for driving the vehicle, and the other operates the GTS.

3.IGNITION SWITCH EXPRESSIONS

HINT:
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.


Expression
Ignition Switch (Position)
Engine Switch (Condition)
Ignition switch off
LOCK
Off (Lock)
Ignition switch ACC
ACC
On (ACC)
Ignition switch ON
ON
On (IG)
Engine Start
START
On (Start)