SFI SYSTEM > DTC CHECK / CLEAR |
| Pending DTC | Store condition | Malfunction detected |
| Clear condition | System determined to be normal or DTCs cleared using GTS or Cable disconnected from negative (-) battery terminal | |
| Current DTC | Store condition | Malfunction detected (2nd trip) |
| Clear condition | No malfunctions in 40 driving cycles or DTCs cleared using GTS or Cable disconnected from negative (-) battery terminal | |
| Permanent DTC | Store condition | Malfunction detected |
| Clear condition | Ignition switch turned to ON after normal judgment obtained in 3 consecutive driving cycles or After DTCs cleared using GTS or cable disconnected from negative (-) battery terminal, normal judgment obtained and universal trip performed (not for misfire and fuel system DTCs) or After DTCs cleared using GTS or cable disconnected from negative (-) battery terminal, malfunction not detected when universal trip driving performed (misfire and fuel system DTCs) | |
| MIL | ON | Malfunction detected |
| OFF | Ignition switch turned to ON after normal judgment obtained in 3 consecutive driving cycles or DTCs cleared using GTS or Cable disconnected from negative (-) battery terminal |


| CHECK DTC |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Check DTCs and freeze frame data, and then write them down.
Check the details of the DTCs (Click here).
| CLEAR DTC (Pending and Current DTC) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Clear DTCs.
| CLEAR DTC (Pending and Current DTC without using GTS) |
Perform either of the following operations:
Disconnect the cable from the negative (-) battery terminal for more than 1 minute.
Remove the EFI (+B) fuse from the engine room relay block assembly located inside the engine compartment for more than 1 minute.
| CLEAR PERMANENT DTC |

Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Check if permanent DTCs are stored.
Clear DTCs.
Perform the respective confirmation driving patterns in order to obtain a normal judgment for the output DTCs.
Perform the universal trip.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Check that the permanent DTCs have been cleared.