Components
| Function and Construction
|
Rear Height Control Sensor Sub-assembly
| Detects the vehicle height.
|
Combination Meter Assembly
| - Outputs the vehicle speed signal to the headlight leveling ECU assembly.
- Headlight beam level control system warning light in the combination meter illuminates for 3 seconds and then turns off when the ignition switch is turned to ON (bulb check function).
- Headlight beam level control system warning light in the combination meter illuminates to alert the driver when a malfunction in this system is detected.
|
Headlight Leveling Motor
| Based on the signals received from the headlight leveling ECU assembly, each motor moves the reflector in the headlight to vary its low beam height.
|
DLC3
| The height control sensor signal initialization and headlight leveling motor operation check can be performed via the DLC3.
|
Headlight Leveling ECU assembly
| - Based on the signals that are transmitted by the height control sensor and combination meter, this ECU detects the amount of variance of the vehicle posture with the vehicle stopped.
- Based on the detected value, this ECU outputs control signals to the headlight leveling motor.
- This ECU turns on the headlight beam level control system warning light for 3 seconds when the ignition switch is turned to ON (bulb check function).
- This ECU turns on the headlight beam level control system warning light to alert the driver when a malfunction in this system is detected.
|