Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuator and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Main Body / Data List.

  5. Read the Data List according to the display on the GTS.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG SW
    Ignition switch ON signal / ON or OFF
    ON: Ignition switch ON
    OFF: Ignition switch off
    -
    ACC SW
    Ignition switch ACC signal / ON or OFF
    ON: Ignition switch ACC
    OFF: Ignition switch off
    -
    Dimmer SW
    Dimmer switch high position signal / ON or OFF
    ON: Dimmer switch in high or high flash position
    OFF: Dimmer switch in low position
    -
    Passing Light SW
    Dimmer switch high flash position (pass) signal / ON or OFF
    ON: Dimmer switch in high flash position
    OFF: Dimmer switch not in high flash position
    -
    Lighting 1
    Light control switch tail position signal / ON or OFF
    ON: Light control switch in tail or head position
    OFF: Light control switch in neither tail nor head position
    -
    Lighting 2
    Light control switch head position signal / ON or OFF
    ON: Light control switch in head position
    OFF: Light control switch not in head position
    -
    Lighting Hi
    Light control switch head (Hi) position signal / ON or OFF
    ON: Headlight high beam on
    OFF: Headlight high beam off
    -
    Rear Fog Light SW*3
    Rear fog light switch signal / ON or OFF
    ON: Rear fog light switch on
    OFF: Rear fog light switch off
    -
    Front Fog Light SW*4
    Front fog light switch signal / ON or OFF
    ON: Front fog light switch on
    OFF: Front fog light switch off
    -
    Rear Fog Lamp Output*3
    Rear fog light output / ON or OFF
    ON: Rear fog light on
    OFF: Rear fog light off
    -
    Rear Fog Lamp Monitor*3
    Rear fog light output / ON or OFF
    ON: Rear fog light on
    OFF: Rear fog light off
    -
    Front Fog Light Output*4
    Front fog light output / ON or OFF
    ON: Front fog light on
    OFF: Front fog light off
    -
    Auto Light SW*1
    Light control switch AUTO position signal / ON or OFF
    ON: Light control switch in AUTO position
    OFF: Light control switch not in AUTO position
    -
    Head Light SW (Head)
    Light control switch head position signal / ON or OFF
    ON: Light control switch in head position
    OFF: Light control switch not in head position
    -
    Head Light SW (Tail)
    Light control switch tail position signal / ON or OFF
    ON: Light control switch in tail or head position
    OFF: Light control switch in neither tail nor head position
    -
    D Door Courtesy SW
    Driver side door courtesy light switch signal / ON or OFF
    ON: Driver side door open
    OFF: Driver side door closed
    -
    Response Time*1
    Delay timing of lighting the taillights when the automatic light control sensor detects brightness change / Normal or Long
    Customize setting displayed
    -
    Illumination Rate Info*1
    Illumination rate information / 0.00 ms. to 2162.65 ms.
    Value is output according to ambient light levels
    -
    Sensitivity*1
    Sensitivity of the automatic light control system / Light2, Light1, Normal, Dark1 or Dark2
    Customize setting displayed
    -
    DRL Function*5
    DRL function / ON or OFF
    Customize setting displayed
    -
    DRL Cancel SW*5
    DRL cancel switch / ON or OFF
    ON: DRL cancel
    OFF: Normal
    -
    DRL Output*5
    DRL output / ON or OFF
    ON: DRL output
    OFF: Normal
    -
    Light Auto OFF Delay*2
    Light auto OFF delay / Off, 30 s, 60 s or 90 s
    Customize setting displayed
    -
    Sudden Braking Notification Function*6
    Sudden braking notification function customize / ON or OFF
    Customize setting displayed
    -
    Left Turn Signal Light
    Left Turn Signal Light output / ON or OFF
    ON: Left turn signal light on
    OFF: Left turn signal light off
    -
    Right Turn Signal Light
    Right Turn Signal Light output / ON or OFF
    ON: Right turn signal light on
    OFF: Right turn signal light off
    -
    Left Turn Signal Switch
    Left turn signal switch signal / ON or OFF
    ON: Left turn signal light on
    OFF: Left turn signal light off
    -
    Right Turn Signal Switch
    Right turn signal switch signal / ON or OFF
    ON: Right turn signal light on
    OFF: Right turn signal light off
    -
    Hazard Switch
    Hazard warning signal switch signal / ON or OFF
    ON: Hazard warning switch on
    OFF: Hazard warning switch off
    -
    Follow Me Home Lighting Time*2
    Changes the lighting time of the follow me home system / 30 s,60 s, 90 s, or 120 s
    Customize setting displayed
    -

    HINT:
    Items for which there are no settings do not appear on the GTS, or do not operate.

    1. *1: w/ Automatic Light Control System
    2. *2: w/ Follow Me Home System
    3. *3: w/ Rear Fog Light
    4. *4: w/ Front Fog Light
    5. *5: w/ Daytime Running Light System
    6. *6: w/ Side Turn Signal Light


ACTIVE TEST

HINT:
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Main Body / Active Test.

  5. Perform the Active Test according to the display on the GTS.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Daytime Running Light*1
    Daytime running lights
    ON/OFF
    -
    Taillight Relay
    Taillight relay
    ON/OFF
    -
    Headlight Relay
    Headlight relay
    ON/OFF
    -
    Headlight Hi
    Headlight (high beam headlights)
    ON/OFF
    -
    Front Fog Light Relay*2
    Front fog light relay
    ON/OFF
    -
    Rear Fog Light Relay*3
    Rear fog light relay
    ON/OFF
    -
    Sudden Braking Notification Signal*4
    Sudden Braking Notification operation
    ON/OFF
    -

    HINT:
    Items for which there are no settings do not appear on the GTS, or do not operate.

    1. *1: w/ Daytime Running Light System
    2. *2: w/ Front Fog Light
    3. *3: w/ Rear Fog Light
    4. *4: w/ Side Turn Signal Light